The gas overpressure regulators RP-6, RP-10 are determined for the single-stage automatic regulation of inlet overpressure of natural gas to lower outlet overpressure.
Outlet overpressure is kept in the specified tolerance with regard to the gas demand quantity, gas pressure fluctuation in pipeline and other adverse effects.

- valve body of grey alloy, other cast stocks of aluminium alloy,
- possibility of turning of the emergency shut-off body by the 90° and regulator body continuously from 0° to 360°,
- in-built safety valve,
- in-built emergency shut-off, which will close permanently the gas inlet to the regulator at gas overpressure
  drop or increase over the specified limit, and due to its construction it is not influenced each other with the regulating
  part of the regulator,
- the regulator is demountable, repairable,
- the service is secured,
- it is equipped with the delivery point for the outlet overpressure check,
- the single parts of the regulator are made out of materials resistant to the gas effects,
- the screen against the impurities penetration in the regulator is the part of the regulator,
- the regulator is possible to be mounted in four positions in accordance with the required gas flow direction (for the flow
  direction bottom-up, top-down and horizontally from the right or from the left). The diaphragm plane always
  must be horizontal and the spring at the top,
- while using of the flanges the regulator enables simple exchange (without installation adjustment) for the regulators
  of the type Alz-6U (the same flanges and dimensions),
- the regulator is included in the group II - small R1 - output to 10 m3.h-1, and that is why it has no specified distances
  from openings in the wall outside of the building,
- the regulator works reliably also at lower inlet overpressure from 0,02 Mpa.

The screen on the inlet.